Categories

Contact Us

Shandong HG Machinery Co.,Ltd
Add:Dianliu Industrial Park, Jinan, China
Tel:+86-531-86418866
Fax:+86-531-86418868
Ph:+8618805413999
E-mail:sales@shandonghg.com

Beer Filling News

- Oct 19, 2018 -

HG-CGF6/6/1 type bottle washing filling capping monoblock machine

6-6-1

Working process

The bottle sent into machine by conveyor belt divided into the fixed interval into machine by star wheel, bottle clip will turnover the bottle and finish washing, then send into the star wheel of bottle filling machine. The bottle will locate in filling valve below by ascension movement of the device. In the process of rotary, the bottles will be passed two procedure of the vacuum and CO2 preparation, and then be in the filling work.

After filling, bottle base fall off, right guiding upward, bottle was sent to transmit star wheel, and then sent into the capping machine star wheel and put under the moulder of the gland plunger. Crown caps are put in the hopper in the top of the machine. Crown cover passes the hopper in storage into a blender and then sent to the head of gland plunger, and then moulder will press below automatically to finish the capping work. After capping, the bottle-out wheel will transfer the gland -finished bottles to the bottle conveyor belt. The all work is finished.

Bottle rinsing part: 6 nozzles

This part is made up of lifting device, the main transmission device, the fixed frame, clamp device, distributor, and open clamp cams and over turn cams etc.

Lifting device is used to adjust the height of the rotary tables and clamps of machine to adapt to the bottle height. Its power comes from the lifting lever. Lever rotates drive screw rotation to realize the rotary tables lift.

When the clamp rotate to star wheel with rotating table, bottle into the middle of clamp, open clamp cam close the clip claw and clip the bottleneck with the rotating clamp. When rotary tables to rotate, clamp pieces will rotate with over turn cam, guide cams rotates around over turn cam and flip the bottleneck to 180 degree till the bottle mouth is top downwards and directly face the spray nozzle, then the clean water in the spray nozzle sprays and wash the inside of the bottle, Drain, turn 180 degree downwards and then goes out from the star wheel.

图片2

Filling part: 6 nozzles

211111

The filling part is made up of main liquid pipe, rotating cylinder bearing base, filling cylinder fulcrum loop, carbonated beverage and beer tank, filling valve, filling cylinder pipe, control loop device, ascending device, the distributor, height adjusting control, stimulating bubble arm, vacuum system, etc.

Capping part: 1head

The capping machine is made up of cap holder, capping slideway, capping upper part, capping lower part, elevating part and anti-circling column.

The up and down movement of the capping nozzle is driven by the capping cam, which is fixed. The crown caps are sending to the cap slideway by a mixer in the cap container, and then slid to the capping mould of the capping nozzle. The capping nozzle is driven by power and move in circle. The capping nozzle would move upword and downward one time in each circle of the capping. The cam, set up in the upper fixed part of the capping machine, controls the upward and downward movement of the capping nozzle.

After the bottle is transmitted from the filling machine, the capping nozzles have been fed with a bottle cap. The capping nozzles moves downwards the bottle under the capping platform driven by cam guideway, then the bottle cap with the aid of the damping ring.

图片4





Previous:No Information

Related Products